ISO 13934-1 Tensile Properties of Fabrics
ISO 13934-1 provides a testing procedure for determining the tensile properties of fabrics. This standard mainly applies to woven textile fabrics, but can also be applicable to fabrics produced using other techniques. it is not normally applied to woven elastic fabrics, geotextiles, nonwoven fabrics, coated fabrics, textile-glass woven fabrics, fabrics made from carbon fibers, or polyolefin tape yarns. Since this testing can be performed on a vast range of fabrics, it is used across a wide range of industries. This standard uses a strip method of testing to measure maximum force as well as elongation at maximum force. If required, it also records the force at rupture and elongation. Two sets of specimens are prepared, one in the warp direction and one in the weft direction.
Standard At A Glance
- ISO 13934-1
Materials Testing System
As with most textiles testing, a high data rate is key to capturing good results. To consistently and accurately measure the tear strength of your material, it is important to remember that the data sampling rate needs to be high enough that the test peaks and troughs are adequately captured. Because of this we recommend a high tier system such as Instron's 6800 Series, which comes equipped with a 5 kHz data acquisition rate. For most testing to ISO 13934-1 a single column frame is appropriate, as the loads rarely rise above 5 kN. Instron’s Bluehill® Universal software can be equipped with a test method suite that provides pre-built calculations for ISO 13934-1 to help simplify testing and ensure compliance.
|ISO 13934-1 Test Setup|
|1)||68SC-5 Universal Testing System
|2)||Bluehill Universal Software
|3)||2580 Series Load Cell
|4)||2712-045 Pneumatic Side-Action Grips
Grips and Accessories
Instron's pneumatic side action grips with rubber faces are well suited for gripping nearly all types of fabric specimens when testing to ISO 13934-1. While manual action grips can also work, pneumatic side action grips are often preferred due to their ease of use, productivity, and better repeatability. Adjustable grip pressure also allows users to fine-tune the gripping pressure to avoid jaw breaks or slippage. ISO 13934-1 calls for smooth and flat jaw faces for testing, but this largely depends on the material being testing. In some cases, serrated jaw faces may be more appropriate for preventing slippage while testing. The standard also for the use of extra material within the jaw faces such as paper or medium grit emery cloth for some fabrics as an additional way to help prevent slippage.
Instron 6800 Series Universal Testing Systems provide unparalleled accuracy and reliability. Built on a patent-pending Operator Protect system architecture with an all-new Smart-Close Air Kit and Collision Mitigation features, the 6800 Series makes materials testing simpler, smarter, and safer than ever before.
Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. Discover simpler and smarter testing with features such as pre-loaded test methods, QuickTest in seconds, enhanced data exporting: and Instron Connect – a new feature that provides a direct communication link to Service. Users of previous versions of software such as Bluehill 2 and Bluehill 3 can easily upgrade to the newest version of Bluehill.